PosiSoft Analysis Software

IR Wireless Portable Printer

Certified Thickness Standards

PosiSoft for Windows analysis software available for Standard (2) models, included with all Memory (3) models.

• Allows entry of notes and annotations
• Prints and displays basic charts and histograms
• Exports to a document or spreadsheet
• Includes USB cable
• Free updates

More Information

Certified Thickness Standards are used to verify the accuracy and operation of coating thickness gages and are an important component in fulfilling both ISO/QS-9000 and in-house quality control requirements.

Contracts often specify that coating thickness measurements be taken by gages whose measurement accuracy is traceable to a National Metrology Institute such as NIST or PTB.

More Information

AC Power Cable for continuous operation.

This kit supplies several alternate power solutions for your battery-operated PosiTector (6000, DPM, 200 & UTG). They allow the gage to operate continuously without the need for batteries. Use the cable alone to connect a PosiTector to your PC's built-in USB port that acts as a continuous power source. Or connect the cable to the included power adaptor which plugs into any AC wall electrical outlet, 110 or 220V. A selection of electrical plugs is included which are capable of dealing with most country’s outlets.

Probe Fixture Stand ensures repeatable positioning.

DeFelsko probes are incredibly accurate, especially the microprobe series. But fine, precise measurements on small parts are often affected by the operator. Our probe fixture removes adverse operator influence by fixturing both the probe and the part. This high quality device is a must in any calibration lab.

Intended primarily for the straight (0 degree) ferrous or non-ferrous microprobes, this stand can also be used with our conventional regular probes. It ensures that the part is brought up to the probe perpendicular to the part’s surface in a controlled, repeatable way.